Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2017.12
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  FAIL-SAFE CHART  


If a problem occurs in the power steering system, the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.

Power Steering System
DTC No. Detection Condition Fail-safe

*: w/ Forward Recognition Camera

C1511/11 Torque sensor malfunction Assist force restricted or power assist stopped
C1512/11
C1513/11
C1514/11
C1515/15
C1516/16
C1517/11
C1521/24 Motor circuit malfunction
C1522/24
C1523/24
C1524/24
C1525/17 Motor rotation angle sensor malfunction
C1526/18
C1528/12
C1531/25 ECU malfunction
C1532/25
C1533/25
C1534/25
C1541/13 Vehicle speed signal malfunction Assist force restricted
C1551/25 IG power source voltage error Power assist stopped
C1552/22 PIG power source voltage error
C1554/23 Power source relay malfunction
C1555/25 Motor relay malfunction
C1581/26 Assist map not written in power steering ECU assembly Controlled using default map
C1582/26 Assist map mismatch written in power steering ECU assembly Controlled using current default map
U0129/42 Skid control ECU communication error Assist force restricted
U023A/45* Forward recognition camera communication error Controls which use forward recognition camera stopped
U0293/41 HV ECU communication error Power assist stopped
U1105/46 Parking assist ECU communication error Power assist control normally (Parking assist system does not operate)

HINT:
·

The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the power switch on (READY).

·

If the auxiliary battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns to normal when the auxiliary battery voltage recovers.