Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0339647 LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) D

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM(w/ Steering Control)  CUSTOMIZE PARAMETERS  


CUSTOMIZE LANE DEPARTURE ALERT SYSTEM (w/ Steering Control)


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



HINT:

The following items can be customized.


a.

Customizing with the Multi-information display

i.

Turn the power switch on (IG).


ii.

Enter the following menus: Settings Tab / Settings / Lane Departure Alert Setup


iii.

Select the setting by referring to the table below.


iv.

Change the settings of the lane departure alert system (w/ steering control) using the steering pad switch assembly.

HINT:

Each item is displayed on the "Setting" screen on the multi-information display.


Lane Departure Alert System (w/ Steering Control)
Display Content Setting Default
Steering Assist Steering control function On/Off On
Alert Sensitivity Timing of lane departure alert High/Standard Standard
Sway Warning Vehicle sway warning function On/Off On
Sway Sensitivity Vehicle sway warning sensitivity High/Standard/Low Standard