Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0339647 LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) J

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM(w/ Steering Control)  Indicator Circuit  


DESCRIPTION

The forward recognition camera sends indicator illumination request signals to the combination meter sub-assembly via CAN communication.

PROCEDURE

1.READ VALUE USING GTS (CAN BUS CHECK)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: System Select / Can Bus Check.


Result:
Result Proceed to
All of the ECUs and sensors that are currently connected to the CAN communication system are displayed A
None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed B



A

2.CHECK FOR DTCs (HEALTH CHECK)

B

2.CHECK FOR DTCs (HEALTH CHECK)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: System Select / Health Check.


e.

Check DTCs.


f.

Turn the power switch off.


Result:
Result Proceed to
No DTCs are output. A
DTCs are output. B



A

3.PERFORM ACTIVE TEST USING GTS

B

GO TO DTC CHART

3.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
LDA Control Indicator Lane departure alert indicator light (Green) OFF or ON -
LDA Warning Indicator Lane departure alert indicator light (Amber) OFF or ON -


f.

Turn the power switch off.


Result:
Result Proceed to
The multi-information display in the combination meter sub-assembly turns on or off according to the operation of the Active Test. A
The multi-information display in the combination meter sub-assembly does not turn on or off according to the operation of the Active Test. B



A

4.READ VALUE USING GTS

B

4.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / LKA/LDA / Data List.


e.

Read the Data List according to the display on the GTS.

Chassis > LKA/LDA > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
LDA Control Control status of lane departure alert system (w/ steering control) Prohibit or Permit Prohibit: Control prohibited
Permit: Control permitted
-


Result:
Result Proceed to
The lane departure alert indicator illuminates and turns on according to the operation of the lane departure alert main switch A
The lane departure alert indicator does not illuminate but the Data List item LDA Control changes according to the operation of the lane departure alert main switch B
The lane departure alert indicator does not illuminate and the Data List item LDA Control does not change according to the operation of the lane departure alert main switch C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER SUB-ASSEMBLY

C

REPLACE FORWARD RECOGNITION CAMERA