Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM › 2017.12–2020.08
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0339649 ROAD SIGN ASSIST SYSTEM C

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  C1AA9  Front Camera Module Beam Axis Not Adjusted  


DESCRIPTION

If forward recognition camera adjustment is not performed after installing the forward recognition camera, DTC C1AA9 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA9 Front Camera Module Beam Axis Not Adjusted 2 seconds after the power switch is turned on (IG), the forward recognition camera detects that forward recognition camera adjustment has not been completed. Forward recognition camera

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



PROCEDURE

1.CHECK FOR DTCs (ROAD SIGN ASSIST SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Road Sign Assist / Trouble Codes.



f.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the power switch on (IG) and wait 2 seconds or more.





Result:
Result Proceed to
DTC C1AA9 is not output A
DTC C1AA9 is output B



A

END

B

2.PERFORM FORWARD RECOGNITION CAMERA ADJUSTMENT
2.PERFORM FORWARD RECOGNITION CAMERA ADJUSTMENT
a.

Perform forward recognition camera adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCs (ROAD SIGN ASSIST SYSTEM)
3.CHECK FOR DTCs (ROAD SIGN ASSIST SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Road Sign Assist / Trouble Codes.



f.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the power switch on (IG) and wait 2 seconds or more.





Result:
Result Proceed to
DTC C1AA9 is not output A
DTC C1AA9 is output B



A

END

B

REPLACE FORWARD RECOGNITION CAMERA