Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2017.12
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR AND MESSAGE


a.

If the pre-crash safety system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.

Master Warning Indicator Warning Message Detail DTC PCS warning light
Illuminated "PRE-CRASH SAFETY MALFUNCTION VISIT YOUR DEALER" Pre-crash safety system malfunctioning Stored Illuminates
Not illuminated "PRE-CRASH SAFETY UNAVAILABLE"
·

Millimeter wave radar sensor assembly misaligned

·

Millimeter wave radar sensor assembly temperature malfunction

·

Millimeter wave radar sensor assembly low voltage malfunction


Not stored Illuminates
Not illuminated "PRE-CRASH SAFETY UNAVAILABLE CLEAN SENSOR" Foreign matter attached to millimeter wave radar sensor assembly Not stored Illuminates
Not illuminated "FRONT CAMERA UNAVAILABLE"
·

Abnormal forward recognition camera voltage

·

Forward recognition camera temperature outside of operational range

·

Other forward recognition camera malfunction


Not stored Illuminates
Not illuminated "FRONT CAMERA VISION BLOCKED CLEAN AND DEMIST WINDSHIELD" Front of forward recognition camera or windshield glass is dirty or misty Not stored Illuminates

HINT:
PCS Warning Light Illumination Status
PCS Warning Light Condition
Illuminates Pre-crash safety system malfunctioning (DTC stored)
Pre-crash safety system temporarily disabled
Pre-crash safety system disabled
Not illuminated Other




INITIAL CHECK


a.

An initial check is performed when the power switch is off for more than 2 seconds and then turned on (IG). The initial check consists of a pre-crash safety system diagnostic check with a duration of approximately 3 seconds.


b.

If a malfunction is detected during the initial check, the PCS warning light in the combination meter sub-assembly will illuminate and a warning message indicating the pre-crash safety system is malfunctioning or disabled will be displayed on the multi-information display.



CONSTANT CHECK


a.

The driving support ECU assembly constantly monitors the pre-crash safety system for malfunctions after the power switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.


b.

If a malfunction is detected during the constant check, the PCS warning light in the combination meter sub-assembly will illuminate and a warning message indicating the pre-crash safety system is malfunctioning or disabled will be displayed on the multi-information display.