Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2017.12
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0293  Lost Communication with HV ECU  


DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect objects in front of the vehicle. Based on signals from the millimeter wave radar sensor assembly, the driving support ECU assembly sends pre-crash safety system control operation signals. These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-crash safety system control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0125 Lost Communication with Yaw Rate Sensor Module When the power switch is on (IG), a communication error between the yaw rate sensor (airbag ECU assembly) and the driving support ECU assembly is detected for approximately 1 second. CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module When the power switch is on (IG), a communication error between the steering sensor (spiral cable with sensor sub-assembly) and the driving support ECU assembly is detected for approximately 4 seconds. CAN communication system
U0129 Lost Communication with Brake System Control Module When the power switch is on (IG), a communication error between the skid control ECU (brake booster with master cylinder assembly) and the driving support ECU assembly is detected for approximately 3 seconds. CAN communication system
U0293 Lost Communication with HV ECU When the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the hybrid vehicle control ECU and the driving support ECU assembly is detected for approximately 5 seconds. CAN communication system

PROCEDURE

1.CHECK FOR DTCs (PRE-CRASH SAFETY SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.



f.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed of 5 km/h (4 mph) or more for 5 seconds or more.





Result:
Result Proceed to
DTC U0125, U0126, U0129 and U0293 are not output A
DTC U0125, U0126, U0129 or U0293 is output B



A

B