Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2017.12
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301930 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT


PROCEDURE

Hide 53289A 1.REMOVE RADIATOR SUPPORT OPENING COVER

a.
B393149

Remove the 3 clips.


b.

Disengage the 3 guides and remove the radiator support opening cover.


Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B393150

Apply protective tape around the front bumper assembly as shown in the illustration.

Text in Illustration
V100155

Protective Tape


b.

w/ Pre-collision System:

i.

Disconnect the connector.



c.
B389037

Remove the screw.

HINT:

Use the same procedure for the RH side and LH side.



d.
B393151

Remove the 6 screws.


e.
B393152

Using a clip remover, remove the 3 clips.


f.

Remove the 4 bolts.


g.
B389040

Disengage the 2 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



h.

Disconnect each connector.


i.
B393153

Remove the front bumper assembly as shown in the illustration.