DTC CHECK/CLEAR
Check for DTCs.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Read the DTCs following the prompts on the GTS screen. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Check the details of the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
Clear the DTCs.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Operate the GTS to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
According to the display on the GTS, select the trouble code data display with the clear button.
END OF DTC CHECK/CLEAR
Turn the power switch on (IG).
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights go off when the power switch is turned on (ready).