CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Disconnect the MB and L190 main body ECU (multiplex network body ECU) connectors.
| *A | for LHD | *B | for RHD |
Measure the voltage and resistance according to the value(s) in the table below.
Measure the values on the wire harness side with the connectors disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| MB-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
| L190-3 (GND2) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| MB-30 (BECU) - Body ground | - | Auxiliary battery power supply | Power switch off | 11 to 14 V |
| MB-29 (ACC) - Body ground | - | ACC power supply | Power switch on (ACC) | 11 to 14 V |
| MB-29 (ACC) - Body ground | - | ACC power supply | Power switch off | Below 1 V |
| MB-32 (IG) - Body ground | - | Power switch power supply | Power switch on (IG) | 11 to 14 V |
| MB-32 (IG) - Body ground | - | Power switch power supply | Power switch off | Below 1 V |
Reconnect the MB and L190 main body ECU (multiplex network body ECU) connectors.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 2B-1 (ACT-) - Body ground | B - Body ground | Door lock motor unlock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2B-1 (ACT-) - Body ground | B - Body ground | Door lock motor unlock drive output | Door control switch (multiplex network master switch) or driver door key cylinder unlocked | 11 to 14 V |
| 2B-3 (ACT-) - Body ground | LG - Body ground | Door lock motor unlock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2B-3 (ACT-) - Body ground | LG - Body ground | Door lock motor unlock drive output | Door control switch (multiplex network master switch) or driver door key cylinder unlocked | 11 to 14 V |
| 2D-11 (ACT-) - Body ground | V - Body ground | Door lock motor unlock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2D-11 (ACT-) - Body ground | V - Body ground | Door lock motor unlock drive output | Door control switch (multiplex network master switch) or driver door key cylinder unlocked | 11 to 14 V |
| 2B-8 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2B-8 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder locked | 11 to 14 V |
| 2B-9 (ACT+) - Body ground | R - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2B-9 (ACT+) - Body ground | R - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder locked | 11 to 14 V |
| 2B-10 (ACT+) - Body ground | P - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2B-10 (ACT+) - Body ground | P - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder locked | 11 to 14 V |
| 2D-12 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder off | Below 1 V |
| 2D-12 (ACT+) - Body ground | L - Body ground | Door lock motor lock drive output | Door control switch (multiplex network master switch) or driver door key cylinder locked | 11 to 14 V |
| 2D-35 (FLCY) - Body ground | Y - Body ground*1
V - Body ground*2 |
Front door LH courtesy light switch input | Front door LH open | Below 1 V |
| 2D-35 (FLCY) - Body ground | Y - Body ground*1
V - Body ground*2 |
Front door LH courtesy light switch input | Front door LH closed | 11 to 14 V |
| 2D-36 (FRCY) - Body ground | BR - Body ground*1
V - Body ground*2 |
Front door RH courtesy light switch input | Front door RH open | Below 1 V |
| 2D-36 (FRCY) - Body ground | BR - Body ground*1
V - Body ground*2 |
Front door RH courtesy light switch input | Front door RH closed | 11 to 14 V |
| L201-6 (LRCY) - Body ground | G - Body ground | Rear door courtesy light switch input | Rear door LH or RH open | Below 1 V |
| L201-6 (LRCY) - Body ground | G - Body ground | Rear door courtesy light switch input | Rear door LH and RH closed | Pulse generation |
| L201-7 (LSFL) - Body ground | GR - Body ground | Front door LH unlock detection switch input | Front door LH unlocked | Below 1 V |
| L201-7 (LSFL) - Body ground | GR - Body ground | Front door LH unlock detection switch input | Power switch off, all doors closed and front door LH locked | Pulse generation |
| L201-18 (LSFR) - Body ground | LG - Body ground | Front door RH unlock detection switch input | Front door RH unlocked | Below 1 V |
| L201-18 (LSFR) - Body ground | LG - Body ground | Front door RH unlock detection switch input | Power switch off, all doors closed and front door RH locked | Pulse generation |
| 2B-29 (LSR) - Body ground | GR - Body ground | Rear door RH unlock detection switch input | Rear door RH or LH unlocked | Below 1 V |
| 2B-29 (LSR) - Body ground | GR - Body ground | Rear door RH unlock detection switch input | Power switch off, all doors closed, rear door RH and LH locked | Pulse generation |
| 2D-25 (LSR) - Body ground | GR - Body ground | Rear door LH unlock detection switch input | Rear door LH or RH unlocked | Below 1 V |
| 2D-25 (LSR) - Body ground | GR - Body ground | Rear door LH unlock detection switch input | Power switch off, all doors closed, rear door LH and RH locked | Pulse generation |
| 2C-23 (BZR) - Body ground | R - Body ground | Wireless door lock buzzer signal | Wireless door lock buzzer off | Below 1 V |
| 2C-23 (BZR) - Body ground | R - Body ground | Wireless door lock buzzer signal | Wireless door lock buzzer on | 11 to 14 V |
*1: for LHD
*2: for RHD
CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
Disconnect the L195 certification ECU (smart key ECU assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| L195-11 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
| L195-2 (+B) - L195-11 (E) | B - W-B | Auxiliary battery power supply | Power switch off | 11 to 14 V |
Reconnect the L195 certification ECU (smart key ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| L197-5 (IG) - L195-11 (E) | BE - W-B | IG power supply | Power switch on (IG) | 11 to 14 V |
| L196-17 (RDAM) - L195-11 (E) | GR - W-B*1
Y - W-B*2 |
RF signal input circuit | Proceed:
1.
All doors closed 2.
All doors locked 3.
Electrical key transmitter sub-assembly not inside vehicle 4.
Electrical key transmitter sub-assembly brought outside detection area but kept inside wireless function operational area 5.
Lock or unlock switch of electrical key transmitter sub-assembly not pressed → pressed |
11 to 14 V pulse generation at regular intervals → pulse generation |
| L196-6 (CSEL) - L195-11 (E) | V - W-B*1
SB - W-B*2 |
Communication channel switching circuit | Proceed:
1.
Power switch off 2.
All doors closed |
No pulse generation → pulse generation |
| L196-5 (RCO) - L195-11 (E) | LG - W-B | Wireless tuner power supply output circuit | Proceed:
1.
Power switch off 2.
Electrical key transmitter sub-assembly brought outside detection area but kept inside wireless function operational area 3.
Lock or unlock switch of electrical key transmitter sub-assembly not pressed → pressed |
Below 1 V → 4.5 to 5.5 V |
*1: for 12 Pin Type
*2: for 5 Pin Type