Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  C1A02  Vehicle Information Not Obtained  


DESCRIPTION

When a new driving support ECU assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or AWD, etc.) from the main body ECU (multiplex network body ECU) and stores the information.

DTC C1A02 is stored when the driving support ECU assembly cannot store the vehicle specification information from the main body ECU (multiplex network body ECU).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A02 Vehicle Information Not Obtained While the power switch is on (IG) and the dynamic radar cruise control system is operating, the driving support ECU assembly cannot store the vehicle specification information for approximately 0.1 seconds or more. Driving support ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.


PROCEDURE

1.CHECK FOR DTC (RADAR CRUISE 2)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).

3.

Wait for 1 second or more.





Result:
Result Proceed to
DTC C1A02 is not output A
DTC C1A02 is output B



A

B

REPLACE DRIVING SUPPORT ECU ASSEMBLY