Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC is stored when there is a malfunction in the hybrid vehicle control ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0575 Cruise Control Input Circuit
·

While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed since cruise cancel signal (STP signal) is received by the hybrid vehicle control ECU.

·

When the power switch is on (IG), STP signals received by the hybrid vehicle control ECU supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more.


Hybrid vehicle control ECU

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.


HINT:

The hybrid vehicle control ECU receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the power switch is turned off.


PROCEDURE

1.CHECK FOR DTCs (RADAR CRUISE 1)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch (ON-OFF button).

3.

Depress the brake pedal for 1 second or more.





Result:
Result Proceed to
DTC P0575 is not output A
DTC P0575 is output B



A

B