Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U0122  Lost Communication with Vehicle Dynamics Control Module  U0293  Lost Communication with Hybrid Vehicle Control System  U1104  Lost Communication with Driving Support ECU  


DESCRIPTION

The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication.

If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0122 Lost Communication with Vehicle Dynamics Control Module When the power switch is on (IG) and the dynamic radar cruise control system is operating, a communication error between the skid control ECU and hybrid vehicle control ECU is detected for approximately 2.6 seconds or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Skid control ECU (brake booster with master cylinder assembly)


U0293 Lost Communication with Hybrid Vehicle Control System While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU continuously receives a communication cut-off signal from the skid control ECU for approximately 1 second or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Skid control ECU (brake booster with master cylinder assembly)


U1104 Lost Communication with Driving Support ECU While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the driving support ECU assembly and hybrid vehicle control ECU is detected for 1 second or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Driving support ECU assembly



PROCEDURE

1.CHECK FOR DTCs (RADAR CRUISE 1)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).

3.

Drive the vehicle at 36 km/h (22 mph) or more for 3 seconds or more.





Result:
Result Proceed to
DTC U0122, U0293 and U1104 are not output A
DTC U0122, U0293 or U1104 is output B



A

B