Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0293  Lost Communication with Hybrid Vehicle Control System  


DESCRIPTION

The driving support ECU assembly communicates with each sensor and ECU via CAN communication.

If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0125 Lost Communication with Yaw Rate Sensor Module While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the yaw rate and acceleration sensor and driving support ECU assembly is detected for approximately 1 seconds or more.
·

CAN communication system

·

Yaw rate and acceleration sensor (airbag ECU assembly)

·

Driving support ECU assembly


U0126 Lost Communication with Steering Angle Sensor Module While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the steering sensor and driving support ECU assembly is detected for approximately 1 seconds or more.
·

CAN communication system

·

Steering sensor

·

Driving support ECU assembly


U0129 Lost Communication with Brake System Control Module While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the skid control ECU and driving support ECU assembly is detected for approximately 2.5 seconds or more.
·

CAN communication system

·

Skid control ECU (brake booster with master cylinder assembly)

·

Driving support ECU assembly


U0293 Lost Communication with Hybrid Vehicle Control System While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the hybrid vehicle control ECU and driving support ECU assembly is detected for approximately 1 seconds or more.
·

CAN communication system

·

Hybrid vehicle control ECU

·

Driving support ECU assembly



PROCEDURE

1.CHECK FOR DTCs (RADAR CRUISE 2)

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Turn the power switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).

3.

Drive the vehicle at 36 km/h (22 mph) or more for 3 seconds or more.





Result:
Result Proceed to
DTC U0125, U0126, U0129 and U0293 are not output A
DTC U0125, U0126, U0129 or U0293 is output B



A

B