Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › from 2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301636 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84632 1.INSPECT CRUISE CONTROL MAIN SWITCH

a.

Measure the resistance according to the value(s) in the table below.

E386218C02
0.583,3 0.792,2.615 true 1.615,3 1.438,2.615 true 0.365,1.948 0.677,2.104 0.313,0.156 10 false *a 0.427,3.063 0.885,3.26 0.458,0.198 10 false CCS 1.5,3.042 1.958,3.24 0.458,0.198 10 false ECC 2.583,2.094 3.354,2.292 0.771,0.198 10 false (ECC) 5.74,3.302 6.51,3.5 0.771,0.198 10 false (CCS) 3.115,2.448 4.031,2.646 0.917,0.198 10 false CANCEL 3.948,2.427 4.865,2.625 0.917,0.198 10 false -SET 4.677,2.417 5.594,2.615 0.917,0.198 10 false +RES 5.396,2.417 6.313,2.615 0.917,0.198 10 false MAIN
*a Component without harness connected
(Cruise Control Switch)
- -


Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (ECC) - 3 (CCS) Cruise control switch (ON-OFF button) released 1 MΩ or higher
Cruise control switch (ON-OFF button) pushed Below 2.5 Ω
+RES 235 to 245 Ω
-SET 617 to 643 Ω
CANCEL 1509 to 1571 Ω



b.

If the result is not as specified, replace the cruise control main switch.