Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › from 2020.08
RM2070E _58 Vehicle Interior _061938 THEFT DETERRENT / KEYLESS ENTRY _0301770 THEFT DETERRENT SYSTEM U

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  TERMINALS OF ECU  


CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


a.

Disconnect the main body ECU (multiplex network body ECU) connectors.

U190874E02
4.167,0.76 4.021,0.76 4.021,0.76 4.021,1.052 false 1.979,1.698 1.677,1.698 false 1.979,2.052 1.677,2.052 false 0.719,2.708 1.042,2.708 false 3.438,7.594 3.729,7.76 0.292,0.167 10 false MB 4.865,6.385 5.156,6.552 0.292,0.167 10 false 2A 1.865,6.385 2.156,6.552 0.292,0.167 10 false 2B 1.156,5.115 1.448,5.281 0.292,0.167 10 false 2D 0.906,1.448 1.115,1.688 0.208,0.24 10 false 2D 4.01,5.115 4.302,5.281 0.292,0.167 10 false 2C 0.906,2.083 1.167,2.438 0.26,0.354 10 false 2C 4.865,3.792 5.156,3.958 0.292,0.167 10 false L7 5.927,5.104 6.219,5.271 0.292,0.167 10 false 2F 2.427,3.802 2.719,3.969 0.292,0.167 10 false L8 0.531,2.635 0.75,2.833 0.219,0.198 10 false 2F 2.01,1.625 2.188,1.76 0.177,0.135 10 false L7 2.01,1.969 2.302,2.135 0.292,0.167 10 false L8 5.875,1.396 6.115,1.688 0.24,0.292 10 false 2B 4.198,0.698 4.427,0.833 0.229,0.135 10 false MB 5.875,2.094 6.104,2.406 0.229,0.313 10 false 2A


b.

Measure the resistance and voltage according to the value(s) in the table below.

HINT:

Measure the value(s) on the wire harness side with the connectors disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
MB-31 (ALTB) - Body ground - Auxiliary battery power supply Power switch off 11 to 14 V
MB-30 (BECU) - Body ground - Auxiliary battery power supply Power switch off 11 to 14 V
MB-29 (ACC) - Body ground - Ignition power supply (ACC signal) Power switch on (ACC) → off 11 to 14 V → Below 1 V
MB-32 (IG) - Body ground - Ignition power supply (IG signal) Power switch on (IG) → off 11 to 14 V → Below 1 V
MB-11 (GND1) - Body ground - Ground Always Below 1 Ω
L8-3 (GND2) - Body ground W-B - Body ground Ground Always Below 1 Ω
MB-2 (FLCY) - Body ground - Front door courtesy light switch LH input Front door LH closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
MB-4 (FRCY) - Body ground - Front door courtesy light switch RH input Front door RH closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
L7-6 (LRCY) - Body ground G - Body ground Rear door courtesy light switch LH and RH input Rear door LH and RH closed (OFF) → rear door LH or RH open (ON) 10 kΩ or higher → Below 1 Ω
L7-19 (BCTY) - Body ground L - Body ground Back door courtesy switch input Back door closed (OFF) → open (ON) 10 kΩ or higher → Below 1 Ω
MB-20 (HCTY) - Body ground - Engine hood courtesy switch input Engine hood open (ON) → closed (OFF) Below 1 Ω → 10 kΩ or higher

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the main body ECU (multiplex network body ECU) connectors.


d.

Measure the voltage according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
L7-7 (LSFL) - Body ground GR - Body ground Front door LH unlock detection switch input Front door LH unlocked Below 1 V
L7-7 (LSFL) - Body ground GR - Body ground Front door LH unlock detection switch input Front door LH locked Pulse generation
L7-18 (LSFR) - Body ground LG - Body ground Front door RH unlock detection switch input Front door RH unlocked Below 1 V
L7-18 (LSFR) - Body ground LG - Body ground Front door RH unlock detection switch input Front door RH locked Pulse generation
2D-25 (LSR) - Body ground GR - Body ground Rear door LH unlock detection switch input Rear door LH or RH unlocked Below 1 V
2D-25 (LSR) - Body ground GR - Body ground Rear door LH unlock detection switch input Rear door LH and RH locked Pulse generation
2B-29 (LSR) - Body ground GR - Body ground Rear door RH unlock detection switch input Rear door LH or RH unlocked Below 1 V
2B-29 (LSR) - Body ground GR - Body ground Rear door RH unlock detection switch input Rear door LH and RH locked Pulse generation
2A-51 (IND) - Body ground G - Body ground Security indicator light up Security indicator light on (It lights up only for 27.5 sec. in alarm sounding state.) 3 to 10 V
2C-24 (HORN) - Body ground SB - Body ground Vehicle horn drive Vehicle horns sounding
(Theft deterrent system in alarm sounding state)
Pulse generation
(Below 1 V ← → 11 to 14 V)
2C-39 (SH) - Body ground Y - Body ground Security horn drive Security horn sounding
(Theft deterrent system in alarm sounding state)
Pulse generation
(Below 1 V ← → 11 to 14 V)

If the result is not as specified, the main body ECU (multiplex network body ECU) may have a malfunction.