Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › from 2020.08
RM2070E _58 Vehicle Interior _061939 LIGHTING (INT) _0301790 LIGHTING SYSTEM Y

LIGHTING (INT)  LIGHTING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the lighting system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
2.CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK
Result:
Proceed to
NEXT



NEXT

3.INSPECT AUXILIARY BATTERY VOLTAGE
3.INSPECT AUXILIARY BATTERY VOLTAGE
a.

Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

4.INSPECT CAN COMMUNICATION SYSTEM*
4.INSPECT CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

Result:
Result Proceed to
CAN communication system DTC is not output. A
CAN communication system DTC is output. B




A

5.PROBLEM SYMPTOMS TABLE

B

5.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*


Result:
Proceed to
NEXT



NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END