FRONT SUSPENSION CROSSMEMBER > TWO-DIMENSIONAL DISTANCE


HINT:
  1. Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Front Suspension Lower Arm Installation Hole
φ16 (0.63)
B, b
Front Suspension Crossmember Installation Hole
φ19 (0.75)
C, c
Steering Gear Installation Hole
φ14.5 (0.57)
D, d
Front Suspension Crossmember Installation Hole
φ17 (0.67)

K104021E01


K104020E02