REAR DOOR OUTER PANEL > CUT AND JOIN REPLACEMENT SECTIONS


K104266

REMOVAL

Symbol meaning
K100023
Cut and Join Location
REMOVAL POINT
  1. After grinding off the hemming location, remove the outer panel.

K104246E01


INSTALLATION

Symbol meaning
K100027
Butt Weld
K100029
Spot MIG Weld
K100030
Body Sealer
INSTALLATION POINT
  1. Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

    NOTICE:
    Do not close the drain hole.

    HINT:
    Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.

  2. Bend the flange hem about 30° with a hammer and dolly. Then, fasten tightly with a hemming tool.

    HINT:
    1. Perform hemming in three steps, being careful not to warp the panel.
    2. If a hemming tool cannot be used, hem with a hammer and dolly.

  3. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K104261E01