REAR FLOOR SIDE MEMBER > CUT AND JOIN REPLACEMENT SECTIONS
With the body lower back panel removed.
REMOVAL
Symbol meaning
Remove Weld Points
Remove Weld Points
Cut and Join Location
REMOVAL POINT
After removing the floor side rail panel sub-assembly Fr, remove the rear floor side member sub-assembly.
INSTALLATION
Symbol meaning
Plug Weld
Plug Weld
Butt Weld
INSTALLATION POINT
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
After welding the rear floor side member sub-assembly to the vehicle side, install the floor side rail panel sub-assembly Fr.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.