SLIDING ROOF SYSTEM > GENERAL |
| OUTLINE |
The sliding roof system uses a glass panel to perform tilt up-and-down and open-and-close operations.
The sliding roof ECU controls the sliding roof system. This ECU uses 2 Hall ICs to detect the position of the sliding roof. The sliding roof ECU and the 2 Hall ICs are integrated in the sliding roof drive gear sub-assembly.
| PRECAUTION |
Ignition Switch Expressions
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Power Switch (Condition) |
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON (IG) | ON (IG) | On (IG) |
| Ignition Switch ON (READY) | ON (READY) | On (Ready) |