VEHICLE PROXIMITY NOTIFICATION SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS

Item
Function
Vehicle Approaching Speaker Controller
Controls starting and stopping of operation, sound pitch and volume level based on signals received from ECUs and sensors.
Vehicle Approaching Speaker Assembly
Emits warning sounds based on the operation signal received from the vehicle approaching speaker controller.
  1. Shift Lock Control Unit Assembly
    1. P Detection Switch
Sends a signal, when the shift lever is in the P position, to the vehicle approaching speaker controller.
Combination Meter Sub-assembly
Sends a vehicle speed signal to the vehicle approaching speaker controller.
Engine Oil Pressure Switch Assembly
Sends an engine running signal to the vehicle approaching speaker controller.
Stop Light Switch Assembly
Sends a brake pedal state signal to the vehicle approaching speaker controller.

OPERATING CONDITION

Condition
Outline
System Active
The vehicle proximity notification system operates (emits a warning sound) when either of the following conditions is met:
  1. The vehicle is stationary (0 km/h or mph), the engine is stopped, the stop light switch is on the shift lever is in any position other than P.*
  2. The vehicle speed is 25 km/h (16 mph) or less, the engine is stopped.
System Stop
The vehicle proximity notification system stops operating when any of the following conditions is met:
  1. The engine starts.
  2. The vehicle speed is 25 km/h (16 mph) or more.
  3. The vehicle is stationary (0 km/h or mph) and the stop light switch on signal is received continuously for more than approximately 1 second.
  4. The vehicle is stationary (0 km/h or mph) and the P position signal is received continuously for more than approximately 1 seconds.
  5. The vehicle is stationary (0 km/h or mph) and the stop light switch off signal is received continuously for more than approximately 3 seconds (e.g. when the vehicle is stopped, and in neutral with the parking brake applied).

HINT:
  1. *: When the system is stopped due to a vehicle speed of 0 km/h (0 mph) and the stop light switch assembly off signal is received continuously for more than approximately 3 seconds, the system operates again when any of the following conditions is met:
    1. A vehicle speed signal of 1 km/h (1 mph) or more is received.
    2. The brake pedal is operated.


SYSTEM CONTROL

Control
Outline
Vehicle Speed Linked Control
  1. Emits the warning sound by controlling the pitch of the sound in accordance with vehicle speed.
  2. The warning sound becomes higher as the vehicle accelerates and it becomes lower as the vehicle decelerates.
Audibility Enhancing Control
When the vehicle proximity notification system is not sounding and the vehicle is stopped (vehicle speed of 0 km/h (0 mph)), if the system operates due to a vehicle speed signal or brake pedal operation (system is changed from being disabled to enabled), the warning sound volume becomes higher than usual for about 1 second to warn people around the vehicle that the vehicle may move.
Fade-in/Fade Out Control
When the system starts operating, the warning sound volume gradually increases*, and when system operation is stopped, the sound volume gradually decreases.

HINT:
*: When audibility enhancing control is performed, the system starts operating using this audibility enhancing control.


DIAGNOSIS
  1. The vehicle approaching speaker controller stores a 5-digit Diagnostic Trouble Code (DTC) in its memory. The 5-digit DTCs can be read after connecting the Techstream to the DLC3.

  2. For details, refer to the respective Repair Manual.