FRONT CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL OIL PUMP SEAL |
Apply MP grease to the lip of a new oil pump seal.
![]() |
Using SST and a hammer, tap in the oil pump seal until its surface is flush with the front oil pump seal retainer edge.
| 2. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY |
Align the hole of the crankshaft damper sub-assembly with the straight pin, then install the crankshaft damper sub-assembly.
![]() |
Using SST, hold the crankshaft damper sub-assembly in place and tighten the bolt.
| *a | Hold |
![]() | Turn |
| 3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
![]() |
Temporarily install the engine mounting insulator sub-assembly RH with the 4 bolts and 2 nuts.
Tighten the 3 bolts (A) in the sequence shown in the illustration.
Tighten the bolt (B) and 2 nuts.
| 4. INSTALL NO. 2 ENGINE ROOM RELAY BLOCK AND NO. 2 JUNCTION BLOCK ASSEMBLY |
Install the No. 2 engine room relay block and No. 2 junction block assembly with the 2 nuts and bolt.
| 5. INSPECT FOR OIL LEAK |
| 6. INSTALL ENGINE UNDER COVER RH |
| 7. INSTALL FRONT WHEEL RH |