FRONT CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE FRONT WHEEL RH |
| 2. REMOVE ENGINE UNDER COVER RH |
| 3. SEPARATE NO. 2 ENGINE ROOM RELAY BLOCK AND NO. 2 JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the bolt and 2 nuts, and separate the No. 2 engine room relay block and No. 2 junction block assembly.
| 4. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
![]() |
Place a jack underneath the engine, then put a wooden block on the jack.
![]() | Jack Position |
![]() |
Remove the 4 bolts, 2 nuts and engine mounting insulator sub-assembly RH.
| 5. REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft damper sub-assembly in place and loosen the bolt.
| *a | Hold |
![]() | Turn |
![]() |
Using SST, remove the crankshaft damper sub-assembly and bolt.
| *a | Hold |
![]() | Turn |
| 6. REMOVE OIL PUMP SEAL |
![]() |
Using a knife, cut off the lip of the oil pump seal.
| *1 | Protective Tape |
| *a | Cut Position |
Using a screwdriver with its tip wrapped with tape, pry out the oil seal.