Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the water filler cap sub-assembly, engine drain cock plug or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the water filler cap sub-assembly and drain the coolant.


    A267952E01


    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Engine Drain Cock Plug
    *4
    Water Filler

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A267960
  1. Remove the stop ring.



    A268695E01
  1. Connect the hose to the engine drain cock plug.
    Text in Illustration 
    *1
    Hose

  1. Pull out the engine drain cock plug and drain the coolant.



2. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


3. REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:
Perform this procedure when the coolant is not hot.



    A267691
  1. Disconnect the 2 heater water hoses.



    A267687
  1. Remove the 4 bolts and 4 compression springs.

  1. Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.



4. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR SUB-ASSEMBLY


    C251099
  1. Remove the nut and 2 bolts and front No. 1 floor heat insulator sub-assembly.



5. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C249908
  1. Disconnect the cable end from the shift lever assembly.



    C249910E01
  1. Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever plate.
    Text in Illustration 
    *1
    Nut
    *a
    Rotate Approximately 180°
    *b
    Disconnect

    NOTICE:
    Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



    C249710E01
  1. Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.
    Text in Illustration 
    *1
    Transmission Control Cable Clamp
    *2
    Transmission Control Cable Support

  1. Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.

  1. Separate the transmission control cable assembly from the transmission control cable clamp and transmission control cable support.



    C251100
  1. Remove the 3 nuts and then remove the transmission control cable assembly from the vehicle exterior.