Terminal No. (Symbol)
| Wiring Color
| Terminal Description
| Condition
| Specified Condition
|
A40-1 (BATT) - C10-16 (E1)
| Y - W-B
| Auxiliary battery (for measuring auxiliary battery voltage and for ECM memory)
| Ignition switch off
| 11 to 16 V
|
A40-2 (+B) - C10-16 (E1)
| B - W-B
| Power source of ECM
| Ignition switch ON (IG)
| 11 to 14 V
|
A40-3 (+B2) - C10-16 (E1)
| B - W-B
| Power source of ECM
| Ignition switch ON (IG)
| 11 to 14 V
|
C10-29 (+BM) - C10-16 (E1)
| BR - W-B
| Power source of throttle actuator
| Ignition switch off
| 11 to 16 V
|
A40-37 (IGSW) - C10-16 (E1)
| P - W-B
| Ignition switch signal
| Ignition switch ON (IG)
| 11 to 14 V
|
C10-75 (OC1+) - C10-74 (OC1-)
| BR - GR
| Camshaft timing oil control valve assembly operation signal
| Idling
| Pulse generation (See waveform 1)
|
A40-46 (MREL) - C10-16 (E1)
| GR - W-B
| EFI MAIN relay operation signal
| Ignition switch ON (IG)
| 11 to 14 V
|
C10-91 (VG) - C10-92 (E2G)
| R - L
| Mass air flow meter sub-assembly signal
| Idling, shift lever in P, A/C switch off
| 0.5 to 3.0 V
|
C10-90 (THA) - C10-122 (ETHA)
| P - G
| Intake air temperature sensor signal
| Idling, intake air temperature 20°C (68°F)
| 0.5 to 3.4 V
|
C10-93 (THW) - C10-94 (ETHW)
| L - BR
| Engine coolant temperature sensor signal
| Idling, engine coolant temperature 80°C (176°F)
| 0.2 to 1.0 V
|
C10-115 (VCTA) - C10-116 (ETA)
| W - V
| Power source of throttle position sensor (specific voltage)
| Ignition switch ON (IG)
| 4.5 to 5.5 V
|
C10-84 (VTA1) - C10-116 (ETA)
| Y - V
| Throttle position sensor signal (for engine control)
| Accelerator pedal fully released
| 0.5 to 1.1 V
|
C10-83 (VTA2) - C10-116 (ETA)
| GR - V
| Throttle position sensor signal (for sensor malfunction detection)
| Accelerator pedal fully released
| 2.1 to 3.1 V
|
C10-23 (HA1A) - C10-52 (E04)
| G - W-B
| Air fuel ratio sensor heater operation signal
| Idling
| Pulse generation (See waveform 2)
|
Ignition switch ON (IG)
| 11 to 14 V
|
C10-133 (A1A+) - C10-16 (E1)
| R - W-B
| Air fuel ratio sensor signal
| Ignition switch ON (IG)
| 3.3 V*
|
C10-134 (A1A-) - C10-16 (E1)
| G - W-B
| Air fuel ratio sensor signal
| Ignition switch ON (IG)
| 2.9 V*
|
C10-22 (HT1B) - C10-52 (E04)
| L - W-B
| Heated oxygen sensor heater operation signal
| Idling
| Below 3.0 V
|
Ignition switch ON (IG)
| 11 to 14 V
|
C10-103 (OX1B) - C10-135 (EX1B)
| L - P
| Heated oxygen sensor signal
| Engine speed maintained at 2500 rpm for 2 minutes after warming up engine
| Pulse generation (See waveform 3)
|
C10-20 (#10) - C10-51 (E01)
| GR - BR
| No. 1 fuel injector assembly signal
| Ignition switch ON (IG)
| 11 to 14 V
|
Idling
| Pulse generation (See waveform 4)
|
C10-17 (#20) - C10-51 (E01)
| P - BR
| No. 2 fuel injector assembly signal
| Ignition switch ON (IG)
| 11 to 14 V
|
Idling
| Pulse generation (See waveform 4)
|
C10-18 (#30) - C10-51 (E01)
| L - BR
| No. 3 fuel injector assembly signal
| Ignition switch ON (IG)
| 11 to 14 V
|
Idling
| Pulse generation (See waveform 4)
|
C10-19 (#40) - C10-51 (E01)
| Y - BR
| No. 4 fuel injector assembly signal
| Ignition switch ON (IG)
| 11 to 14 V
|
Idling
| Pulse generation (See waveform 4)
|
C10-123 (KNK1) - C10-124 (EKNK)
| R - G
| Knock control sensor signal
| Engine speed maintained at 2500 rpm after warming up engine
| Pulse generation (See waveform 5)
|
C10-82 (VV1+) - C10-114 (VV1-)
| L - W
| Camshaft position sensor signal
| Idling
| Pulse generation (See waveform 6)
|
C10-78 (NE+) - C10-110 (NE-)
| G - R
| Crank position sensor signal
| Idling
| Pulse generation (See waveform 6)
|
A40-43 (G2O) - C10-16 (E1)
| B - W-B
| Camshaft revolution signal
| Idling
| Pulse generation (See waveform 7)
|
C10-57 (IGT1) - C10-16 (E1)
| W - W-B
| No. 1 ignition coil assembly (ignition signal)
| Idling
| Pulse generation (See waveform 8)
|
C10-56 (IGT2) - C10-16 (E1)
| V - W-B
| No. 2 ignition coil assembly (ignition signal)
| Idling
| Pulse generation (See waveform 8)
|
C10-55 (IGT3) - C10-16 (E1)
| G - W-B
| No. 3 ignition coil assembly (ignition signal)
| Idling
| Pulse generation (See waveform 8)
|
C10-54 (IGT4) - C10-16 (E1)
| LG - W-B
| No. 4 ignition coil assembly (ignition signal)
| Idling
| Pulse generation (See waveform 8)
|
C10-102 (IGF1) - C10-16 (E1)
| Y - W-B
| Ignition coil assembly (ignition confirmation signal)
| Ignition switch ON (IG)
| 4.5 to 5.5 V
|
Idling
| Pulse generation (See waveform 8)
|
C10-76 (PRG) - C10-51 (E01)
| L - BR
| Purge VSV operation signal
| Ignition switch ON (IG)
| 11 to 14 V
|
Idling, under purge control
| Pulse generation (See waveform 9)
|
C10-60 (M+) - C10-59 (ME01)
| W - BR
| Throttle actuator operation signal (positive terminal)
| Idling with warm engine
| Pulse generation (See waveform 10)
|
C10-30 (M-) - C10-59 (ME01)
| B - BR
| Throttle actuator operation signal (negative terminal)
| Idling with warm engine
| Pulse generation (See waveform 11)
|
A40-21 (FC) - C10-51 (E01)
| R - BR
| Fuel pump control
| Ignition switch ON (IG)
| 11 to 14 V
|
A40-27 (W) - C10-16 (E1)
| B - W-B
| Malfunction Indicator Lamp (MIL) operation signal
| Ignition switch ON (IG) (MIL goes on)
| Below 3.0 V
|
Idling
| 11 to 14 V
|
A40-23 (TC) - C10-16 (E1)
| P - W-B
| Terminal TC of DLC3
| Ignition switch ON (IG)
| 11 to 14 V
|
A40-31 (TACH) - C10-16 (E1)
| LG - W-B
| Engine speed signal
| Idling
| Pulse generation (See waveform 12)
|
A40-34 (VCPP) - A40-36 (EPPM)
| V - BE
| Power source of canister pressure sensor (specific voltage)
| Ignition switch ON (IG)
| 4.5 to 5.5 V
|
A40-5 (VPMP) - C10-51 (E01)
| G - BR
| Vent valve (built into canister pump module)
| Ignition switch ON (IG)
| 11 to 14 V
|
A40-18 (MPMP) - C10-51 (E01)
| BR - BR
| Leak detection pump (built into canister pump module)
| Leak detection pump off
| Below 3.0 V
|
Leak detection pump on
| 9 to 14 V
|
A40-35 (PPMP) - A40-36 (EPPM)
| L - BE
| Canister pressure sensor (built into canister pump module)
| Ignition switch ON (IG)
| 3.0 to 3.6 V
|
A40-13 (CANH) - C10-16 (E1)
| L - W-B
| CAN communication line
| Ignition switch ON (IG)
| Pulse generation (See waveform 13)
|
A40-26 (CANL) - C10-16 (E1)
| W - W-B
| CAN communication line
| Ignition switch ON (IG)
| Pulse generation (See waveform 14)
|
A40-12 (CANP) - C10-16 (E1)
| B - W-B
| CAN communication line
| Ignition switch ON (IG)
| Pulse generation (See waveform 13)
|
A40-25 (CANN) - C10-16 (E1)
| W - W-B
| CAN communication line
| Ignition switch ON (IG)
| Pulse generation (See waveform 14)
|
A40-28 (WPI) - C10-16 (E1)
| G - W-B
| Engine water pump assembly signal
| Idling with warm engine
| Pulse generation (See waveform 15)
|
A40-29 (WPO) - C10-16 (E1)
| L - W-B
| Engine water pump assembly signal
| Idling with warm engine
| Pulse generation (See waveform 16)
|
C10-118 (VCPM) - C10-119 (EPIM)
| P - LG
| Power source of manifold absolute pressure sensor
| Ignition switch ON (IG)
| 4.75 to 5.25 V
|
C10-87 (PIM) - C10-119 (EPIM)
| B - LG
| Manifold absolute pressure sensor signal
| Ignition switch ON (IG)
| 3.0 to 5.0 V
|
C10-28 (EGR1) - C10-16 (E1)
| R - W-B
| EGR valve assembly
| EGR valve operating
| Pulse generation (See waveform 17)
|
C10-27 (EGR2) - C10-16 (E1)
| G - W-B
| EGR valve assembly
| EGR valve operating
| Pulse generation (See waveform 17)
|
C10-26 (EGR3) - C10-16 (E1)
| W - W-B
| EGR valve assembly
| EGR valve operating
| Pulse generation (See waveform 17)
|
C10-25 (EGR4) - C10-16 (E1)
| Y - W-B
| EGR valve assembly
| EGR valve operating
| Pulse generation (See waveform 17)
|
A40-45 (RFC) - C10-16 (E1)
| LG - W-B
| Cooling fan control
| Ignition switch ON (IG), A/C switch on (max cool)
| Pulse generation (See waveform 18)
|
A40-50 (EC) - Body ground
| W-B - -
| Earth (ground) circuit of ECM
| Always
| Below 1 Ω
|
C10-16 (E1) - Body ground
| W-B - -
| Earth (ground) circuit of ECM
| Always
| Below 1 Ω
|
C10-51 (E01) - Body ground
| BR - -
| Earth (ground) circuit of ECM
| Always
| Below 1 Ω
|
C10-21 (E02) - Body ground
| B - -
| Earth (ground) circuit of ECM
| Always
| Below 1 Ω
|
C10-52 (E04) - Body ground
| W-B - -
| Earth (ground) circuit of ECM
| Always
| Below 1 Ω
|
C10-59 (ME01) - Body ground
| BR - -
| Earth (ground) circuit of ECM
| Always
| Below 1 Ω
|
C10-58 (GE01) - Body ground
| BR - -
| Shielded earth (ground) circuit of throttle actuator
| Always
| Below 1 Ω
|