SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
Check and ensure the following conditions:
Auxiliary battery voltage is 11 V or higher.
Accelerator pedal fully released.
Shift lever is in P or N.
A/C switch is off.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Check that the MIL flashes as shown in the illustration.
Turn the ignition switch to ON (READY).
Check that the MIL turns off.
Simulate the conditions of the malfunction described by the customer.
Check the DTCs and freeze frame data using the Techstream.