Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

B281049E05

  1. Disconnect the instrument panel junction block assembly and main body ECU (multiplex network body ECU) connectors.

  2. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    3C-21 (BECU) - Body ground
    L - Body ground
    Auxiliary battery power supply
    Ignition switch off
    11 to 14 V
    3E-1 - Body ground
    B - Body ground
    Auxiliary battery power supply
    Ignition switch off
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Measure the resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    3B-8 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  4. Reconnect the instrument panel junction block assembly and main body ECU (multiplex network body ECU) connectors.

  5. Measure the voltage and check for pulses according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    3C-2 - Body ground
    G - Body ground
    Taillight relay drive signal output
    Light control switch in tail or head position
    11 to 14 V
    Light control switch off
    Below 1 V
    3D-10 - Body ground
    G - Body ground
    Taillight relay drive signal output
    Light control switch in tail or head position
    11 to 14 V
    Light control switch off
    Below 1 V
    3C-18 (HRLY) - Body ground
    V - Body ground
    Headlight relay drive output
    Light control switch in head position
    11 to 14 V
    Light control switch not in head position
    Below 1 V
    3A-28 (PKB) - Body ground
    R - Body ground
    Parking brake switch input
    Parking brake switch on
    Below 1 V
    Parking brake switch off
    11 to 14 V
    3C-22 (DRL) - Body ground
    L - Body ground
    Daytime running light system drive output
    Daytime running light system operating
    Below 1 V
    Daytime running light system not operating
    11 to 14 V
    3C-7*1 - Body ground
    L - Body ground
    Front fog light drive output
    Light control switch in head position, front fog light switch on
    11 to 14 V
    Light control switch in head position, front fog light switch off
    Below 1 V
    3C-35 (DIM) - Body ground
    P - Body ground
    High beam headlight drive output
    Dimmer switch in high or high flash position
    Below 1 V
    Dimmer switch in low position
    11 to 14 V
    G59-5 (HU) - Body ground
    L - Body ground
    Dimmer switch high position signal input
    Dimmer switch in high position
    Below 1 V
    Dimmer switch not in high position
    Pulse generation
    G59-8 (HF) - Body ground
    L - Body ground
    Dimmer switch high flash position signal input
    Dimmer switch in high flash position
    Below 1 V
    Dimmer switch not in high flash position
    Pulse generation
    G59-27 (FFOG)*1 - Body ground
    GR - Body ground
    Front fog light switch input
    Front fog light switch on
    Below 1 V
    Front fog light switch off
    Pulse generation
    G59-28 (DRLC)*2 - Body ground
    R - Body ground
    Light control switch DRL position signal input
    Light control switch in DRL position
    Below 1 V
    Light control switch not in DRL position
    Pulse generation
    G59-29 (HEAD) - Body ground
    L - Body ground
    Light control switch head position input
    Light control switch in head position
    Below 1 V
    Light control switch not in head position, ignition switch off
    Pulse generation
    Light control switch not in head position, ignition switch ON (IG)
    11 to 14 V
    G59-30 (TAIL) - Body ground
    SB - Body ground
    Light control switch tail position signal input
    Light control switch in tail or head position
    Below 1 V
    Light control switch in neither tail nor head position, ignition switch off
    Pulse generation
    Light control switch in neither tail nor head position, ignition switch ON (IG)
    11 to 14 V

    1. *1: w/ Front Fog Light
    2. *2: Headlight dimmer switch w/ DRL OFF function
    If the result is not as specified, the main body ECU (multiplex network body ECU) or instrument panel junction block assembly may be malfunctioning.