Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › SHIFT LEVER POSITION SENSOR

SHIFT LEVER POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER LH


2. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    C249709
  1. Remove the nut and clip and separate the transmission control cable assembly from the transmission control shaft lever and No. 1 transmission control cable bracket.



3. REMOVE SHIFT LEVER POSITION SENSOR


    C250068
  1. Disconnect the connector from the shift lever position sensor.



    C250069
  1. Remove the nut, washer, and transmission control shaft lever from the shift lever position sensor.



    C250070E01
  1. Using a screwdriver, pry the tabs of the lock plate.
    Text in Illustration 
    *1
    Lock Plate



    C250071E01
  1. Remove the lock nut and lock plate from the manual valve shaft.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Lock Plate



    C250072
  1. Remove the 2 bolts and pull out the shift lever position sensor from the manual valve shaft.



    C251614E01
  1. Using a screwdriver with its tip taped, remove the shift lever position sensor seal.
    Text in Illustration 
    *1
    Vinyl Tape

    NOTICE:
    1. It is not always necessary to replace or remove/install the shift lever position sensor seal at the same time when replacing the shift lever position sensor.
    2. When removing the shift lever position sensor seal, be sure not to damage the case or manual shaft with the screwdriver.

    HINT:
    Remove/install the shift lever position sensor seal only if oil leaks from the shift lever position sensor seal or other faults are found when the shift lever position sensor is removed.