Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the water filler cap sub-assembly, engine drain cock plug or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the water filler cap sub-assembly and drain the coolant.


    A267952E01


    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Engine Drain Cock Plug
    *4
    Water Filler

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A267960
  1. Remove the stop ring.



    A268695E01
  1. Connect the hose to the engine drain cock plug.
    Text in Illustration 
    *1
    Hose

  1. Pull out the engine drain cock plug and drain the coolant.



2. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A270241
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.

  1. Remove the gasket from the front exhaust pipe assembly.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:
Perform this procedure when the coolant is not hot.



    A267691
  1. Disconnect the 2 heater water hoses.



    A267690
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.

  1. Remove the gasket from the exhaust manifold.