Home › Engine / Hybrid System › 1NZ-FXE COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the water filler cap sub-assembly, engine drain cock plug or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the water filler cap sub-assembly and drain the coolant.


    A267952E01


    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Engine Drain Cock Plug
    *4
    Water Filler

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A267960
  1. Remove the stop ring.



    A268695E01
  1. Connect the hose to the engine drain cock plug.
    Text in Illustration 
    *1
    Hose

  1. Pull out the engine drain cock plug and drain the coolant.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A267396
  1. Disconnect the ventilation hose.



    A267397
  1. Disconnect the purge VSV.



    A267398
  1. Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Release the 2 clamps.



    A267400
  1. Loosen the hose clamp and remove the air cleaner cap sub-assembly.



3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
  1. Remove the air cleaner filter element sub-assembly.



    A267683
  1. Remove the 2 bolts, grommet and air cleaner case sub-assembly.



4. DISCONNECT NO. 2 RADIATOR HOSE


    A267996
  1. Disconnect the No. 2 radiator hose from the engine assembly.



5. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY


    A267958E01
  1. Disconnect the water inlet hose and No. 3 water by-pass hose.
    Text in Illustration 
    *1
    Water Inlet Hose
    *2
    No. 3 Water By-pass Hose

    NOTICE:
    1. Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 3 water by-pass hose.
    2. Do not damage the water inlet with thermostat sub-assembly.



    A267959
  1. Remove the 2 bolts and water inlet with thermostat sub-assembly.



    A267962
  1. Remove the gasket from the water inlet with thermostat sub-assembly.