FUEL PRESSURE REGULATOR > REMOVAL |
| 1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
| 2. REMOVE FUEL SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the fuel sender gauge assembly connector.
![]() |
Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.
| 3. REMOVE FUEL PUMP WITH FILTER ASSEMBLY |
![]() |
Disconnect the connector of the fuel pump harness.
![]() |
Disconnect the suction filter hose.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump with filter assembly from the No. 1 fuel sub-tank.
| *1 | No. 1 Fuel Sub-tank |
| *2 | Fuel Tube |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump with filter assembly from the fuel filter.
| *1 | Fuel Filter |
| *2 | Suction Filter |
![]() |
Disconnect the fuel pump harness connector.
![]() |
Remove the O-ring and fuel pump spacer from the fuel pump with filter assembly.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |
| 4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly.
![]() |
Remove the 2 O-rings from the fuel pressure regulator assembly.
| *1 | O-ring |