Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Install the spiral cable with sensor sub-assembly .

    NOTICE:
    1. Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON.
    2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the ignition switch ON.
    3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
    4. Do not remove the steering angle sensor from the spiral cable.



2. INSTALL UPPER STEERING COLUMN COVER


    C248044
  1. Engage the 2 claws to install the upper steering column cover.



3. INSTALL LOWER STEERING COLUMN COVER


    C256915
  1. Engage the 4 claws to install the lower steering column cover.



    C248042
  1. Install the 3 screws.



4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD


5. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B296308
  1. Rotate the spiral cable with sensor sub-assembly counterclockwise slowly by hand until it stops.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.



    B296309E01
  1. Rotate the spiral cable with sensor sub-assembly clockwise approximately 2.5 turns to align the marks.
    Text in Illustration 
    *a
    Alignment Mark

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



6. INSTALL STEERING WHEEL ASSEMBLY