WINDOW DEFOGGER WIRE > ON-VEHICLE INSPECTION |
| 1. CHECK REAR WINDOW DEFOGGER OPERATION |
When the ignition switch is ON (IG) and the rear window defogger switch is pressed, check that the window defogger system operates.
| 2. INSPECT REAR WINDOW DEFOGGER WIRE (BACK DOOR GLASS) |
![]() |
Turn the ignition switch ON (IG).
| *1 | Rear Window Defogger Wire |
| *a | Tester Probe |
| *b | Tin Foil |
Turn the rear window defogger switch on.
![]() |
Measure the voltage at the center of each rear window defogger wire to check the wire as shown in the illustration.
| *a | Foil Strip |
| *b | At center |
| Voltage | Criteria |
| 4 to 6 V | Wire is not broken |
| 11 to 14 V | Wire is broken between the center and ground side end |
| Below 1 V | Wire is broken between the center and auxiliary battery side end |
![]() |
Place the positive (+) lead of the voltmeter against the rear window defogger wire on the auxiliary battery side.
| *a | 11 to 14 V |
| *b | Below 1 V |
| *c | Ground Side |
| *d | Auxiliary Battery Side |
| *e | Foil Strip |
| *f | Broken Wire |
Place the negative (-) lead of the voltmeter with the foil strip against the wire on the ground side.
Slide the positive (+) lead from the auxiliary battery side to the ground side. The point where the voltage drops to below 1 V from 11 to 14 V is the place where the rear window defogger wire is broken.