Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY


    G022405
  1. Disposal using a drill

    1. Fully extend the piston rod and secure the rear shock absorber assembly at an angle in a vise.

    2. Using a drill, slowly make a hole at the position indicated by the arrow in the illustration to discharge the gas inside.

      CAUTION:
      Be careful when drilling because shards of metal may fly about, so always use proper safety equipment.

      HINT:
      The gas is colorless, odorless and non-poisonous.