SIDE AIRBAG SENSOR (for Rear Side) > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE FRONT FLOOR COVER LH (for LH Side) |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover LH.
| 5. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 8 claws and remove the front door scuff plate LH.
| 6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 7. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 5 claws and guide and remove the rear door scuff plate LH.
| 8. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
| 9. REMOVE CENTER PILLAR LOWER GARNISH |
![]() |
Disengage the 4 claws and 2 clips, and remove the center pillar lower garnish LH.
| 10. REMOVE SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Disconnect the connector from the side airbag sensor assembly.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Slide | *b | Push |
Push down the white housing lock again and disconnect the connector.
Remove the bolt and side airbag sensor assembly from the vehicle body.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Correct | *b | Incorrect |