Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY

KNEE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B296314E01
  1. Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
    Text in Illustration 
    *1
    Airbag Connector
    *2
    Airbag Connector Lock

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Push in the airbag connector lock to install the airbag connector.

  1. Temporarily install the lower No. 1 instrument panel airbag assembly with the 7 claws and the 3 guides.

  1. Install the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



2. INSTALL LOWER STEERING COLUMN COVER


    C256915
  1. Engage the 4 claws to install the lower steering column cover.



    C248042
  1. Install the 3 screws.



3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


4. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B296308
  1. Rotate the spiral cable with sensor sub-assembly counterclockwise slowly by hand until it stops.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.



    B296309E01
  1. Rotate the spiral cable with sensor sub-assembly clockwise approximately 2.5 turns to align the marks.
    Text in Illustration 
    *a
    Alignment Mark

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



5. INSTALL STEERING WHEEL ASSEMBLY