Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)


  1. Disconnect the Q3 sliding roof ECU (sliding roof drive gear assembly) connector.


    B270994E07

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    Q3-8 (B) - Q3-12 (E)
    B - W-B
    Auxiliary battery power supply
    Ignition switch off
    11 to 14 V
    Q3-1 (IG) - Q3-12 (E)
    V - W-B
    IG power supply
    Ignition switch off
    Below 1 V
    Q3-1 (IG) - Q3-12 (E)
    V - W-B
    IG power supply
    Ignition switch ON (IG)
    11 to 14 V
    Q3-12 (E) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the Q3 sliding roof ECU (sliding roof drive gear assembly) connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    Q3-7 (OPN) - Q3-12 (E)
    W - W-B
    Sliding roof motor open
    Ignition switch ON (IG), OPEN switch on
    Below 1 V
    Q3-7 (OPN) - Q3-12 (E)
    W - W-B
    Sliding roof motor open
    Ignition switch ON (IG), OPEN switch off
    11 to 14 V
    Q3-5 (CLS) - Q3-12 (E)
    P - W-B
    Sliding roof motor close
    Ignition switch ON (IG), CLOSE switch on
    Below 1 V
    Q3-5 (CLS) - Q3-12 (E)
    P - W-B
    Sliding roof motor close
    Ignition switch ON (IG), CLOSE switch off
    11 to 14 V
    Q3-4 (UP) - Q3-12 (E)
    G - W-B
    Sliding roof motor up
    Ignition switch ON (IG), UP switch on
    Below 1 V
    Q3-4 (UP) - Q3-12 (E)
    G - W-B
    Sliding roof motor up
    Ignition switch ON (IG), UP switch off
    11 to 14 V
    Q3-6 (DWN) - Q3-12 (E)
    L - W-B
    Sliding roof motor down
    Ignition switch ON (IG), DOWN switch on
    Below 1 V
    Q3-6 (DWN) - Q3-12 (E)
    L - W-B
    Sliding roof motor down
    Ignition switch ON (IG), DOWN switch off
    11 to 14 V
    If the result is not as specified, the sliding roof ECU (sliding roof drive gear assembly) may be malfunctioning.