Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

SLIDING ROOF SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



GENERAL
This system has the following functions: manual slide open and close; auto slide open and close; manual tilt up and down; auto tilt up and down; jam protection; key off operation; sliding roof open warning.

FUNCTION OF MAIN COMPONENT

Component
Outline
Sliding roof ECU (Sliding roof drive gear assembly)
The sliding roof ECU (sliding roof drive gear assembly) controls the rotational direction of the motor, which tilts or slides the sliding roof glass.
Sliding roof switch (Map light assembly)
The sliding roof switch (map light assembly) outputs operation signals to the sliding roof ECU (sliding roof drive gear assembly).

SYSTEM OPERATION
The sliding roof has the following features.

Function
Outline
Manual slide open and close
This function causes the sliding roof to open (or close) when the OPEN switch (or CLOSE switch) is pressed for a maximum of 0.3 seconds. The sliding roof stops as soon as the switch is released.
Auto slide open and close*1, *2
This function causes the sliding roof to reach the comfort stop position or fully open (or fully close) when the OPEN switch (or CLOSE switch) is pressed for a minimum of 0.3 seconds.
Manual tilt up and down
This function causes the sliding roof to tilt up (or tilt down) when the UP switch (or DOWN switch ) is pressed for a maximum of 0.3 seconds. The sliding roof stops as soon as the switch is released.
Auto tilt up and down*1, *2
This function causes the sliding roof to fully tilt up (or tilt down) when the UP switch (or DOWN switch) is pressed for a minimum of 0.3 seconds.
Jam protection*2
The jam protection function automatically stops the sliding roof and moves it open halfway (or fully tilt up) if a foreign matter gets jammed in the sliding roof during close or tilt down operation.
Key-off operation*2
The key-off operation function makes it possible to operate the sliding roof for approximately 43 seconds after the ignition switch is turned to ACC or off, if the front doors are not opened.
Sliding roof open warning*1, *2
When the ignition switch is turned from ON (IG) to off and the driver door is opened with the sliding roof open, the buzzer in the combination meter assembly sounds once. Then, a warning message appears on the multi-information display.
  1. *1: This function can be customized (Click here). If the customize setting is OFF, this function does not operate.
  2. *2: If the sliding roof ECU (sliding roof drive gear assembly) has not been initialized, this function does not operate.