Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SRS SEAT CUSHION AIRBAG ASSEMBLY

SRS SEAT CUSHION AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the front seat airbag sub-assemblies.



1. INSPECT FRONT SEAT AIRBAG SUB-ASSEMBLY (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the front seat airbag sub-assemblies installed on the vehicle.

    HINT:
    The defects are as follows:
    1. Cuts on the front seat cushion assembly around the front seat airbag sub-assemblies
    2. Small cracks on the front seat cushion assembly around the front seat airbag sub-assemblies
    3. Significant discoloration on the front seat cushion assembly around the front seat airbag sub-assemblies

    OK:
    No defects are found.

    If any of the defects is found, replace the separate type front seat cushion pad or separate type front seat cushion cover with a new one.



2. INSPECT FRONT SEAT AIRBAG SUB-ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the front seat airbag sub-assemblies removed from the vehicle.

    HINT:
    The defects are as follows:
    1. Cuts
    2. Small cracks
    3. Significant discoloration
    4. Cracks or other damage to the connector

    OK:
    No defects are found.

    If any of the defects is found, replace the front seat airbag sub-assembly with a new one.