Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    E138242E91
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    a1-1 - a1-2
    -10°C (14°F)
    7.30 to 9.10 kΩ
    a1-1 - a1-2
    -5°C (23°F)
    5.65 to 6.95 kΩ
    a1-1 - a1-2
    0°C (32°F)
    4.40 to 5.35 kΩ
    a1-1 - a1-2
    5°C (41°F)
    3.40 to 4.15 kΩ
    a1-1 - a1-2
    10°C (50°F)
    2.70 to 3.25 kΩ
    a1-1 - a1-2
    15°C (59°F)
    2.14 to 2.58 kΩ
    a1-1 - a1-2
    20°C (68°F)
    1.71 to 2.05 kΩ
    a1-1 - a1-2
    25°C (77°F)
    1.38 to 1.64 kΩ
    a1-1 - a1-2
    30°C (86°F)
    1.11 to 1.32 kΩ

    Text in Illustration 
    *a
    Component without harness connected
    (Evaporator Temperature Sensor (No. 1 Cooler Thermistor))
    *b
    Sensing Portion
    *c
    Resistance (kΩ)
    *d
    Allowable Range
    *e
    Temperature (°C (°F))

    NOTICE:
    1. Touching the sensor even slightly may change the resistance value. Hold the sensor connector.
    2. When measuring the resistance, the temperature of the sensor and the evaporator temperature sensor (No. 1 cooler thermistor) must be the same.

    HINT:
    As the temperature increases, the resistance decreases (See the graph).

    1. If the operation is not as specified, replace the evaporator temperature sensor (No. 1 cooler thermistor).