Home › Engine / Hybrid System › 1NZ-FXE STARTING › POWER SWITCH

POWER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER SWITCH


  1. Measure the resistance according to the value(s) in the table below.


    A260269E06

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (SS1) - 6 (AGND)
    Pushed
    Below 1 Ω
    1 (SS2) - 6 (AGND)
    Pushed
    Below 1 Ω
    5 (SS1) - 6 (AGND)
    Not pushed
    10 kΩ or higher
    1 (SS2) - 6 (AGND)
    Not pushed
    10 kΩ or higher

    If the result is not as specified, replace the power switch.



  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the power switch.


    A260269E07


    Text in Illustration 
    *a
    Power Switch Illumination
    -
    -

    Standard Resistance:
    Measurement Condition
    Specified Condition
    Auxiliary battery positive (+) →Terminal 9 (SWIL)
    Auxiliary battery negative (-) →Terminal 6 (AGND)
    Illuminates
    (Power Switch Illumination)

    If the result is not as specified, replace the power switch.