Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > INITIALIZATION

for Preparation Click here



MAINTENANCE REQUIRED REMINDER RESET PROCEDURE

HINT:
The ODO/TRIP change switch is located on the right side of the steering pad switch assembly.

  1. Turn the power switch on (IG).

  2. Press the ODO/TRIP change switch until the ODO meter appears.

  3. Turn the power switch off.

  4. Turn the power switch on (IG). The multi-information display's initial screen will be displayed for a few seconds. While the initial screen is being displayed, press the ODO/TRIP switch 3 times, pressing and holding the ODO/TRIP change switch on the third times. Hold the ODO/TRIP change switch until the following conditions are met and 5 seconds have elapsed.

    1. The ODO meter shows "000000".

    2. The multi-information display shows that the reset is complete.