ELECTRONICALLY CONTROLLED BRAKE SYSTEM > CALIBRATION |
| DESCRIPTION |
After replacing any VSC related components or performing wheel alignment adjustment, clear and read the sensor calibration data.
Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration.
| Part to be Replaced / Operation | Necessary Operation |
| Skid control ECU (Brake booster with master cylinder assembly) | Yaw rate and acceleration sensor zero point calibration |
| Yaw rate and acceleration sensor (Airbag sensor assembly) |
|
| Wheel alignment adjustment |
|
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When Using the Techstream) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is centered.
Check that the shift lever is in P.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Select the skid control ECU to clear the zero point calibration data using the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Reset Memory.
Turn the ignition switch off.
Perform the zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is centered.
Check that the shift lever is in P.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Switch the skid control ECU to Test Mode using the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.
After Test Mode has been entered, keep the vehicle stationary on a level surface for 3 seconds or more.
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights come on for several seconds and then blinks in the Test Mode pattern.
Turn the ignition switch off and disconnect the Techstream.
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When not Using the Techstream) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is centered.
Check that the shift lever is in P.
Turn the ignition switch to ON (IG).
![]() |
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
| *a | Front view of DLC3 |
Check that no codes other than ABS code 42, VSC code 45 and electronically controlled brake system code 48, 66, or 95 are stored in the diagnostic system.
Turn the ignition switch off.
Perform zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is centered.
Check that the shift lever is in P.
![]() |
Using SST, connect terminals TS and CG of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON (IG).
After Test Mode has been entered, keep the vehicle stationary on a level surface for 3 seconds or more.
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights come on for several seconds and then blinks in the Test Mode pattern.
Turn the ignition switch off and disconnect SST from the DLC3.