Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM


C147971E41


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU AND RECEIVER - AUXILIARY BATTERY AND BODY GROUND)


    C239106E07
  1. Disconnect the tire pressure warning ECU and receiver M17 or M20 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    M17-1 (IG) - Body ground*1
    M20-1 (IG) - Body ground*2
    Ignition switch ON
    10 to 16 V
    Ignition switch off
    Below 1 V

    1. *1: w/ Smart Key System
    2. *2: w/o Smart Key System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M17-12 (GND) - Body ground*1
    M20-12 (GND) - Body ground*2
    Always
    Below 1 Ω

    1. *1: w/ Smart Key System
    2. *2: w/o Smart Key System
    Text in Illustration 
    *A
    w/ Smart Key System
    *B
    w/o Smart Key System
    *a
    Front view of wire harness connector
    (to Tire Pressure Warning ECU and receiver)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)