Home › Vehicle Exterior › WINDOW / GLASS › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT DEFOGGER RELAY


    B202136
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Auxiliary battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    3 - 4
    Auxiliary battery voltage not applied between terminals
    Below 1 Ω
    3 - 5
    Auxiliary battery voltage applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Auxiliary battery voltage not applied between terminals
    10 kΩ or higher
    4 - 5
    Always
    10 kΩ or higher

    If the result is not as specified, replace the defogger relay.