SMART KEY SYSTEM (for Entry Function) > Driver Side Door Entry Lock Function does not Operate |

| 1.CHECK POWER DOOR LOCK CONTROL SYSTEM |
When the door control switch on the multiplex network master switch assembly is operated, check that the doors unlock and lock according to the switch operation (Click here).
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (LOCK SENSOR) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D-Door Trigger Switch | Driver door touch sensor (lock sensor) / ON or OFF | ON: Driver door touch sensor (lock sensor) touched OFF: Driver door touch sensor (lock sensor) not touched |
|
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH - CERTIFICATION ECU) |
Disconnect the J10 front door outside handle assembly LH (for driver door) connector.
Disconnect the G54 and G55 certification ECU (smart key ECU assembly) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J10-1 (TRG+) - G54-7 (TSW1) | Always | Below 1 Ω |
| G55-1 (E) - Body ground | Always | Below 1 Ω |
| J10-1 (TRG+) or G54-7 (TSW1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH (FOR DRIVER DOOR) (DRIVER DOOR LOCK SENSOR SIGNAL INPUT) |
Connect the J10 front door outside handle assembly LH (for driver door) connector.

| *1 | Waveform | - | - |
| *a | Component with harness connected (Certification ECU (smart key ECU assembly)) | *b | In actuality, sampling is being performed |
Connect the G54 and G55 certification ECU (smart key ECU assembly) connectors.
Using an oscilloscope, check the waveform.
| Tester Connection | Switch Condition | Tool Setting | Specified Condition |
| G54-7 (TSW1) - G55-1 (E) | Procedure:
| 2 V/DIV., 500 ms/DIV. | Pulse generation (See waveform) |
|
| ||||
| OK | ||
| ||