Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0AA7-727    Hybrid Battery Voltage Isolation Sensor Circuit

for Preparation Click here


DESCRIPTION

The power management control ECU monitors the insulation monitoring circuit located in the battery smart unit and detects a malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0AA7
727
Malfunction in the insulation monitoring circuit in the battery voltage sensor
(1 trip detection logic)
Battery smart unit

Related Data List 
DTC No.
Data List
P0AA7-727
Short Wave Highest Val

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the ignition switch to ON (IG) and wait for 70 seconds or more.

1.CLEAR DTC

NEXT


2.SIMULATION TEST
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and wait for 1 minute or more.

    NOTICE:
    Do not turn the power switch off until step 3 is complete.

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0AA7-727 is not output
    A
    P0AA7-727 is output
    B



B
REPLACE BATTERY SMART UNIT
A


3.SIMULATION TEST

NOTICE:
Do not turn the power switch off while performing this inspection.

  1. With the vehicle and engine stopped, turn the power switch on (READY) with park (P) selected and wait for 1 second or more. (If the engine starts, wait until the engine stops.)

  1. While depressing the brake pedal without depressing the accelerator pedal, move the shift lever to D and wait for 1 minute. (Step A)

  1. Drive the vehicle 50 cm (1.6 ft.) forward and perform step A.

  1. Drive the vehicle another 50 cm (1.6 ft.) forward and perform step A. Repeat this procedure 5 times (minimum total driving distance: 2 m (6.6 ft.)).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0AA6 is not output
    A
    P0AA6 is output
    B



B
GO TO DTC CHART (P0AA6)
A

REPLACE BATTERY SMART UNIT