Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    A307401E01
  1. Check that the float moves smoothly between F and E.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)

  1. Check the fuel sender gauge assembly resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Float Level
      Specified Condition
      1 - 2
      F
      13.5 to 16.5 Ω
      Between F and E
      13.5 to 414.5 Ω (Gradually changes)
      E
      405.5 to 414.5 Ω

      If the value is not as specified, replace the fuel sender gauge assembly.