HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION |
| 1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY |
Pass the hood lock control cable assembly into the engine compartment.
Pass the cable through the upper radiator support.
Engage the hood lock control cable assembly to the 3 clamps and grommet to connect the hood lock control cable assembly.
| 2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.
Engage the 3 claws to install the hood lock control lever sub-assembly.
| 3. INSTALL HOOD LOCK ASSEMBLY |
Apply MP grease to the sliding areas of the hood lock assembly.
Connect the hood lock control cable.
Install the hood lock with the 3 bolts.
| 4. INSTALL COWL SIDE TRIM BOARD LH |
Engage the clip.
Install the cowl side trim board with the clip.
| 5. INSTALL FRONT DOOR SCUFF PLATE LH |
Engage the 8 claws to install the front door scuff plate.
| 6. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance measurements of areas "a" through "f" are within each standard range.

| Area | Measurement | Area | Measurement |
| a | -0.85 to 3.15 mm (-0.0335 to 0.124 in.) | b | 1.65 to 5.65 mm (0.0650 to 0.222 in.) |
| c | -1.85 to 2.15 mm (-0.0728 to 0.0847 in.) | d | 2.35 to 6.35 mm (0.0925 to 0.250 in.) |
| e | 2.0 to 5.0 mm (0.0787 to 0.197 in.) | f | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| 7. ADJUST HOOD SUB-ASSEMBLY |
Horizontally and vertically adjust the hood.
![]() |
Loosen the 4 hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the 4 hinge bolts after the adjustment.
Adjust the height of the front end of the hood using the cushion rubbers.
![]() |
Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.
Adjust the hood lock.
![]() |
Loosen the 3 bolts.
Tighten the bolts after adjustment.
Check that the striker can engage with the hood lock smoothly.
| 8. INSTALL FRONT FENDER LINER LH |