Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL LH


2. REMOVE FRONT FENDER LINER LH

HINT:
Use the same procedure for the RH side and LH side .



3. REMOVE FRONT DOOR SCUFF PLATE LH


    B300786
  1. Disengage the 8 claws and remove the front door scuff plate LH.



4. REMOVE COWL SIDE TRIM BOARD LH


    B300787
  1. Remove the clip.

  1. Disengage the clip and remove the cowl side trim board LH.



5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B284569
  1. Disengage the 3 claws and disconnect the hood lock control lever sub-assembly.

  1. Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.



6. REMOVE HOOD LOCK ASSEMBLY


    B297001
  1. Remove the 3 bolts.



    B301501
  1. Disconnect the hood lock control cable and remove the hood lock assembly.



7. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver, disengage the hood lock control cable assembly from the 3 clamps and hood cable grommet as shown in the illustration.


    B301503E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Clamp
    *3
    Hood Cable Grommet
    -
    -

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment and remove it.